100 crimp ring terminals for heat sealer elements

What is for sale: 100 crimp ring terminals for heat sealer elements

---

100 Crimp Ring Terminal Ends for Heat Sealer Elements Round or Flat
100 Crimp Ring Terminal Ends for Heat Sealer Elements
Fix your Elements or Make your own with some 24 or 26 ga nichrome wire.
These also work with 1/16 to 1/8 nichrome ribbon.
These will fit most hand sealers such as TEW-200, TISH-200 FS-200
WHEN LOOKING AT OTHER KITS MAKE SURE YOU ARE GETTING THE PROPER PARTS NECESSARY FOR A PROPER JOB, YOU SHOULD HAVE THE FOLLOWING
* 1 REPLACEMENT Element (wire)
* 1 Teflon Fabric 5 mil cover that goes over the element 1.125" wide
* 1 Piece of 1/2 inch teflon tape(adhesive) 10 mil that goes under the element.
Failure to replace the teflon tape that insulates the element from the body of the sealer will cause premature failure of the element and may cause failure of the timing circuit or transformer.